Question 1 - Protocol Analysis with Wireshark
Objective: gain a good understanding of common Internet protocols as well as using packet
capture software (Wireshark).
The file a01-assignment-1-question-1-capture.pcap on Moodle contains packets
captured in an exchange between several computers. Use the file to answer the following subquestions.
Some sub-questions refer to only a specific set of packets in the capture.
a) Considering all the packets in the file, draw a message sequence diagram that
illustrates the packets. A message sequence diagram uses vertical lines to represent
events that happen at a computer over time (time is increasing as the line goes down).
Addresses of the computers/software are given at the top of the vertical lines.
Horizontal or sloped arrows are used to show messages (packets) being sent between
computers. Each arrow should be labelled with the protocol, packet type and important
information of the message. An example of a portion of the message sequence diagram
for packets 6 and 7 are shown below. You must draw a diagram that shows all packets.
b) For the following sets of packets from the capture, give a short explanation
of their purpose/meaning. For example, why were they sent? Which computer sent
them? To which computer(s) did they send them to? What is the important information
in each packet? What is achieved from the packet exchange?
i. Packets 1 and 2
ii. Packets 3, 4 and 5
iii. Packets 6, 7, 8 and 9
iv. Packets 10 and 11
v. Packets 12, 13 and 14
Question 2 – Application Attacks
Objective: be able to interpret packet captures and identify security weaknesses in web
You have performed a man-in-the-middle attack allowing you to capture packets between two
computers. The two computers are named/addressed as follows:
ï‚· Web Browser computer: 192.168.1.11
ï‚· Web Server computer: 192.168.2.21
The website is a university grading system: students and staff can log in and view grades of
courses they are involved with (staff or admin users can also edit grades). Students should not
be able to view other students’ grades, nor edit grades.
The packets you captured are in file a01-assignment-1-question-2-capture.pcap (on
Moodle). They involve a student, with student ID 5012345678, on the web browser computer
using the grading website. Unfortunately (for you) the actual login packets were encrypted
d) Regarding the attack in the part (c), check if your favourite web browser allows
you to perform the attack. If so, explain what to do with that browser (e.g. “In Mozilla
Firefox on Windows 8.1, open the File menu and select …”). If not, then explain other
software/techniques you could use to perform the attack (e.g. “On Windows 8.1 install
the software … and then …”). Don’t forget to include the name of your favourite
browser in the answer. Note that you do not have to perform the steps – you only need
to find out what they are.
e) Now assume you have also obtained (through other means) the source code
of the file view.php in the grades directory on the web server. The file is on Moodle
and renamed as a01-assignment-1-question-2-view.php. Assuming your attack
from part (c) was successful and you are currently logged in as student 5012345678,
explain a different attack you can perform to view the grades of other students. In your
answer, explain what you would do to perform the attack and which lines of code in
view.php you take advantage of for the attack. Note that you can’t use the same attack
as part (c); your attack should make use of view.php.
f) Regarding the attack in part (d), explain how view.php could be modified
such that the attack would be unsuccessful.
(using HTTPS) and therefore are not included
Question 3 – Designing Firewalls [11 marks]
Objective: be able to design packet filtering firewall rules and identify
advantages/disadvantages of such firewalls.
An educational institute has a single router, referred to as the gateway router, connecting its
internal network to the Internet. The institute has the public address range 22.214.171.124/16 and
the gateway router has address 126.96.36.199 on its external interface (referred to as interface
ifext). The internal network consists of four subnets:
A DMZ, which is attached to interface ifdmz of the gateway router and uses address
A small network, referred to as shared, with interface ifint of the gateway router
connected to a second router, referred to as the internal router. This network has no
hosts attached (only two routers) and uses network address 10.2.0.0/16.
A staff subnet, which is for use by staff members only, that is attached to the internal
router and uses network address 10.2.1.0/24.
A student subnet, which is for use by students only, that is attached to the internal router
and uses network address 10.2.2.0/24.
In summary, there are two routers in the network: the gateway router is attached to three subnets
(external, DMZ and shared); and the internal router is also attached to three subnets (shared,
staff and students).
There are three servers in the DMZ that all can accept requests from the Internet: a web server
supporting HTTP and HTTPS, a secure shell server using SSH, and a SMTP email server.
Internal staff and students can also access the web and secure shell servers; they can access the
email server but using IMAP.
The gateway router also runs a stateful packet filtering firewall and performs port address
translation. In addition to the DMZ setup as described above, security requirements for the
educational institute are:
1. External Internet users cannot access any internal computers (except in DMZ).
2. Both staff members and students can access websites in the Internet.
3. Staff, students and others may have accounts on the SSH server in the DMZ. However,
staff also have the additional requirement that if they login to the SSH server from the
Internet (e.g. while they are at home or travelling), they can then initiate a 2nd SSH
connection from the SSH server to their office computer on the staff subnet (this
assumes staff office computers also have SSH servers running). Staff can use this to
remotely access their office PCs from home. Students (and others outside the institute)
are not allowed to do this.
4. The Head of the institute finds performing two SSH connections to access their office
computer too difficult. They have requested that they be able to directly SSH from their
home computer to their office computer, bypassing the SSH server in the DMZ. The
Head has a fixed IP at home: 188.8.131.52.
Considering the above information, answer the following questions:
a) Draw a diagram illustrating the network. Although there may be many
computers in the staff and student subnets, for simplicity you only have to draw three
computers in the staff subnet and three computers in the student subnet. One of the three
in the staff subnet should be the Head’s office computer. Label all computers and router
interfaces with IP addresses.
b) Specify the firewall rules using the format as in the table below. You may
add/remove rows as needed. in the file. Only the packets from after the login
Give a short explanation of the rules. Also identify any potential issues with
the rules (that is, in practice what could go wrong when using your firewall rules) and
d) Consider the Port Address Translation service on the gateway router. The
following table shows the addresses of packets arriving on interface ifint at the router.
The packets are listed in order at which they arrive at the router. Complete the addresses
for the packets as they are sent out on interface ifext of the router.
Question 4 – Vulnerability Research [7 marks]
Objective: research advanced malware and identify the basic techniques they are built upon.
New malware is being discovered regularly by security researchers. As the malware is
discovered, detection techniques are developed, but then malware developers improve their
malware to avoid detection. This cycle has led to very advanced malware, using a combination
of basic techniques. One widely publicised malware was Stuxnet. In 2010 Stuxnet was
discovered to have used various techniques to infect industrial control systems (which were not
connected to the Internet), with the possible purpose of shutting down facilities in Iran that
developed nuclear material. The techniques used have been linked to other attacks, and the
Your task is to gain a basic understanding of how Stuxnet worked and recommend procedures
for avoiding similar types of advanced malware. A detailed explanation of Stuxnet is provided
by Symantec at:
a) Summarise how Stuxnet worked. Refer to the concepts learnt in lectures in
your description (e.g. malware traits of circulation, infection, concealment, payload;
was it a logic bomb? did it use spam? …).
b) Provide a set of recommendations for how to avoid being impacted by
Stuxnet or similarly complex malware. For example, consider you are the Security
Manager in a company with large and important industrial control systems (e.g. power
companies, defence facilities, manufacturing) and you need to produce a concise list of
recommendations to avoid Stuxnet like attacks to the Chief Information Security
Officer. The recommendations should be justified, e.g. “Recommendation 1: do this
because of this reason”. The number of recommendations should be appropriate for the
number of different techniques Stuxnet uses.
are in the file.
By using only the file a01-assignment-1-question-2-capture.pcap and the information
in this question, answer the following sub-questions.
a) Describe the actions of the student using the web browser. That is, give the
links they clicked on (or typed in), the exact time when they clicked on it (relative to
the first packet captured), any parameters or form fields they filled in, and what was
displayed on their web browser as a result. You may give your answer as a list, for
- At time 0.0 the student clicked on link … . As a result they were shown a webpage
that welcomed them, had a link to “View grades”, “Logout” and to several help
- At time …
b) List all information you know about the student’s computer (including
addresses and software it uses). For each item of information, explain where you found
the item in the capture. For example, one item of information is the IP address:
- The student’s computer has IP address 192.168.1.11 as identified in the IP header
of each packet.
- The student’s computer …
c) Explain how you could use the captured packets to perform an attack that
allows you to login as the student. In your answer, refer to the packets (and information
in them) that allow the attack and give a general explanation of how to perform the