As part of restructuring at the Cyber University, a new Faculty of Innovation has been established. The faculty encompasses Computer Science and Engineering disciplines. You have been tasked to design the network for the new faculty. TheDefault_Gateway and Router01 are part of the existing network. The faculty has been assigned 143.78.60.0/23address spacePart 1Divide the assigned address space(143.78.60.0/23)equally between CS, and ENG subnets.Part 2Construct the following network topology in GNS3 simulator. Ensure that all the hostnames and network addresses are well labeled, including the network addresses you worked out in Part 1.Use Cisco 3725 routers.
Part 3Configure all the routers using the assigned hostnames and IP address. Configure the routers to use RIP to automatically update the routing tables.You should be able to ping the Default_Gateway from Router02 and vice versa.[Hint Use RIP version 2 with no auto-summary]Part 4Setup Virtual PC (FA1, CS1, EN1)in each of the three subnets as shown above. The virtual PC’s provide lightweight PC environment to executetools such as ping, and trace route. Each VPC should be able to ping the others.Part 5The Faculty Admin subnet will be hosting services meantfor access by staffonly. Configure the access control list (ACL) on Router03such that any traffic from thestudent subnet (143.78.64.0/22) is blocked from entering the Faculty Admin subnet. Traffic to and from other subnets shouldpass through.Pinging ST1(a VPC in student subnet)from FA1 (VPC in Faculty Admin subnet) should fail. Likewise pinging FA1 from ST1should also fail. On the other hand you should succeed inpinging the Default_Gateway from FA1, CS1 or EN